Measurements (mm)× 4in kit
- Outer diameterOD41 mm
- Inner diameterID18.5 mm
- Length34 mm
- Flange thicknessFL8 mm
- Flange outer diameterFLOD50 mm
Centre tubeOD × ID × length, mm19 × 12.3 × 70.6× 2
SuperPro rear control arm bush kit
Key specs
- PositionRear axle
- Install time3 hours
- Kits required24 bushings, 2 tubes
- AlignmentNeeded after fitting
- Engineering-grade polyurethane
- Unaffected by heat, oils, water and coolant
- Designed in Australia
Before you fit
- A wheel alignment is needed after fitting.
- Some vehicles have their own fitment note. Check your vehicle in the table before ordering.
- The part supplied is named differently on some vehicles (shown as 'Sold as' in the table).
About this control arm bush kit
The SuperPro SPF0611K rear control arm bush kit replaces soft factory rubber, which is designed for ride comfort and noise isolation but over time softens, cracks and allows excess movement that dulls handling and can affect alignment. The low-compliance polyurethane controls flex, twist and deflection for sharper steering response, more consistent geometry under load and a more connected, predictable feel without the harshness of solid mounts.
Note -INNER AND OUTER - IRS vehicles require 2 kits if not using adjuster kits (SPF2545K).
SuperPro SPF0611K
Specifications
Kit
| Kit type | Rear Control Arm Bush Kit (IRS) |
|---|---|
| Kits required | 2 |
| Components per kit | 4 Bushings, 2 Tubes |
Fitting
| Fitting position | Rear |
|---|---|
| Install time | 3 hours |
| Wheel alignment required | Yes |
Identifiers
| SKU | SPF0611K |
|---|---|
| EAN | 9317745006114 |
SuperPro SPF0611K
Bush dimensions
All sizes in millimetres. The letters on each drawing match the letters on the measurements beside it.
SuperPro warranty
Lifetime warrantyBall joints, tie rod ends, Duroballs and links: 3 year / 60,000kmThis SuperPro part is covered by a lifetime warranty against manufacturing defects, for on-road, off-road, track and competition use. The warranty covers replacement of the original component only. Ball joints, tie rod ends, Duroballs and links are covered for 3 year / 60,000km.
This product: SPF0611K is protected by a lifetime warranty
Our warranty is in addition to your rights under the Australian Consumer Law.
Proof of purchase
Proof of purchase is required, such as your order number. Keep the part and any related components until your claim is finalised.
Common exclusions
- Finish, corrosion and normal wear
- Damage from installation, installation error or not aligning the wheels after fitting
- Labour and consequential costs
- Not fitted to the catalogue-listed application
- Not purchased from Northman
How to make a claim
Fill in the Warranty Request form with your order number, the product, your vehicle details, how the vehicle is used and a description of the problem.
We'll reply within 3–5 business days and ask for clear photos or videos of the part, the problem area and how it's fitted.
Most claims are diagnosed from photos or videos.
SPF0611K
Vehicle fitment
74 vehicles
Choose your vehicle to check fitmentWe’ll tell you if this fits and where it goes.
One position: Rear11 vehicle-specific notesSold as differs on 26 vehicles
Where the title changes by vehicle
For most vehicles this part is sold as Control Arm - Bushing Kit. 26 vehicles have a different listing, marked Sold as in the table. Check which one you need before ordering.
Applies to every vehicle unless flagged
- Standard Alignment
Check before ordering
| Vehicle | Years | Position |
|---|---|---|
| HDT CommodoreVT Sport | 1997–2000 | Rear |
| HDT CommodoreVX Areo SignatureSuits models to - 07/2001 | 2000–2002 | Rear |
| Holden AdventraVY | 2003–2004 | Rear |
| Holden AdventraVZ | 2004–2009 | Rear |
| Holden CalaisVP | 1991–1993 | Rear |
| Holden CalaisVR, VS | 1993–1997 | Rear |
| Holden CalaisVT | 1997–2000 | Rear |
| Holden CalaisVXSuits models to - 07/2001 | 2000–2002 | Rear |
| Holden CalaisVYSold as: Control Arm - Outer Bushing Kit | 2002–2004 | Rear |
| Holden CalaisVZSold as: Control Arm - Outer Bushing Kit | 2004–2006 | Rear |
| Holden CapriceVQ | 1990–1994 | Rear |
| Holden CapriceVR, VS | 1994–1999 | Rear |
| Holden CapriceWHSuits models to - 07/2001 | 1999–2003 | Rear |
| Holden CapriceWK | 2003–2004 | Rear |
| Holden CapriceWL | 2004–2006 | Rear |
| Holden CommodoreVN, VP SedanSuits IRS models | 1988–1993 | Rear |
| Holden CommodoreVR, VS SedanSuits IRS models | 1993–1997 | Rear |
| Holden CommodoreVT Sedan and Wagon | 1997–2000 | Rear |
| Holden CommodoreVU Ute | 2000–2002 | Rear |
| Holden CommodoreVX Sedan and WagonSuits models to - 07/2001 | 2000–2002 | Rear |
| Holden CommodoreVY Sedan and WagonSold as: Control Arm - Outer Bushing Kit | 2002–2004 | Rear |
| Holden CommodoreVY UteSold as: Control Arm - Outer Bushing Kit | 2002–2004 | Rear |
| Holden CommodoreVZ Sedan and WagonSold as: Control Arm - Outer Bushing Kit | 2004–2007 | Rear |
| Holden CommodoreVZ UteSold as: Control Arm - Outer Bushing Kit | 2004–2007 | Rear |
| Holden MonaroV2Sold as: Control Arm - Outer Bushing Kit | 2001–2004 | Rear |
| Holden MonaroVZSold as: Control Arm - Outer Bushing Kit | 2004–2006 | Rear |
| Holden StatesmanVQ | 1990–1994 | Rear |
| Holden StatesmanVR, VS | 1994–1999 | Rear |
| Holden StatesmanWH | 1999–2003 | Rear |
| Holden StatesmanWKSold as: Control Arm - Outer Bushing Kit | 2003–2004 | Rear |
| Holden StatesmanWLSold as: Control Arm - Outer Bushing Kit | 2004–2006 | Rear |
| HSV CapriceVR, VS | 1994–1996 | Rear |
| HSV ClubsportVP | 1991–1993 | Rear |
| HSV ClubsportVR-VS SEDAN | 1993–1997 | Rear |
| HSV ClubsportVT | 1997–2000 | Rear |
| HSV ClubsportVXSuits models to - 08/2001 | 2000–2002 | Rear |
| HSV ClubsportY SERIESSold as: Control Arm - Outer Bushing Kit | 2002–2004 | Rear |
| HSV ClubsportZ SERIESSold as: Control Arm - Outer Bushing Kit | 2004–2006 | Rear |
| HSV Coupe 4V2, Z SERIESSold as: Control Arm - Outer Bushing Kit | 2004–2006 | Rear |
| HSV GrangeVS | 1996–1999 | Rear |
| HSV GrangeWHSuits models to - 08/2001 | 1999–2003 | Rear |
| HSV GrangeWKSold as: Control Arm - Outer Bushing Kit | 2003–2004 | Rear |
| HSV GrangeWLSold as: Control Arm - Outer Bushing Kit | 2004–2006 | Rear |
| HSV GTOV2 COUPESold as: Control Arm - Outer Bushing Kit | 2001–2004 | Rear |
| HSV GTOZ SERIES COUPESold as: Control Arm - Outer Bushing Kit | 2002–2007 | Rear |
| HSV GTSV2 COUPESold as: Control Arm - Outer Bushing Kit | 2001–2004 | Rear |
| HSV GTSVR, VS | 1993–1997 | Rear |
| HSV GTSVT | 1997–2000 | Rear |
| HSV GTSVXSold as: Control Arm - Outer Bushing Kit | 2000–2002 | Rear |
| HSV GTSY SERIESSold as: Control Arm - Outer Bushing Kit | 2002–2007 | Rear |
| HSV MalooVU | 2001–2002 | Rear |
| HSV MalooY SERIESSold as: Control Arm - Outer Bushing Kit | 2002–2004 | Rear |
| HSV MalooZ SERIESSold as: Control Arm - Outer Bushing Kit | 2004–2007 | Rear |
| HSV MantaVS SEDAN | 1995–1997 | Rear |
| HSV MantaVT | 1997–1999 | Rear |
| HSV SenatorVP | 1992–1993 | Rear |
| HSV SenatorVR, VS | 1993–1997 | Rear |
| HSV SenatorVT | 1997–2000 | Rear |
| HSV SenatorVXSold as: Control Arm - Outer Bushing Kit | 2000–2002 | Rear |
| HSV SenatorY SERIESSold as: Control Arm - Outer Bushing Kit | 2002–2004 | Rear |
| HSV SenatorZ SERIESSold as: Control Arm - Outer Bushing Kit | 2004–2006 | Rear |
| HSV StatesmanVQ | 1990–1993 | Rear |
| HSV StatesmanVR, VS | 1994–1996 | Rear |
| HSV SV300VX | 2001–2001 | Rear |
| HSV SV6000Z SERIESSold as: Control Arm - Outer Bushing Kit | 2005–2006 | Rear |
| HSV SV99VT | 1999–2000 | Rear |
| HSV XU6VT | 1998–2000 | Rear |
| HSV XU6VXSuits models to - 08/2001 | 2000–2002 | Rear |
| HSV XU8VT | 1999–1999 | Rear |
| Toyota LexcenVN, VP SedanSuits IRS models | 1987–1993 | Rear |
| Toyota LexcenVR, VS SedanSuits IRS models | 1993–1997 | Rear |
| Vauxhall CalibraGM2900 | 1989–1997 | Rear |
| Vauxhall CarltonMk2 | 1977–1986 | Rear |
| Vauxhall CarltonMk3 | 1986–1994 | Rear |
No vehicles match.
Does this fit my car?
Your vehicle
Pick any vehicle. If it is not on this product's fitment list, we cannot guarantee fitment.
Questions about fitment? Call 1800 292 911 before you order.
